Network Instruments GigaStor 114ff Manuel d'utilisateur télécharger pdf (Page 20)

Setting the GigaStor’s IP address

Chapter 2 Installing Your GigaStor

rev. 1

4 Ensure that each drive’s power/activity light is lit. If a drive’s light

is not lit, it is likely that the drive is not seated properly. Turn off

the GigaStor and reseat the drives. For more information, see

“Installing the drives in your GigaStor” on page 50.

5 Log in using the Administrator account. The default

Administrator password is admin.

6 Click Start → Control Panel → Network and Internet Connections

→ Network Connections. Choose Local Area Connection and

right-click and choose Properties.

7 Select Internet Protocol (TCP/IP) from the list and click

Properties (Figure 2).

Figure 2 Default TCP/IP settings

8 Set the IP address, subnet mask, gateway, and DNS server for your

environment and click OK. Click OK again to close the Local

Area Connection Properties dialog. Close the Network

Connections window.

9 Right-click the Probe Service Configuration Applet in the system

tray and choose Open Probe Configuration.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 145 146

Pas de commentaire

Network Instruments GigaStor 114ff Manuel d'utilisateur Page 20